CATEGORY


 

    OUR SALES TEAM

   Call Sales Consultant :
   (021) 2664 8999

    Corporate Order :
   info@datascrip.co.id

 

 

 

ACU HID V300





PRODUCT HIGHLIGHT

The HID VertX® products provide a complete and fully featured hardware/firmware infrastructure for access control software host systems.

The V300 output control interface contains 12 latching Form-C relays, which can connect up to 12 devices controllable by simple contact closures, such as logic inputs for process equipment, HVAC and elevator control panels, CCTV switchers, etc. Loads exceeding 2 A @ 30 VDC should be controlled via interposing relays.

The V300 features on-board flash memory, allowing program updates to be downloaded via the network. The V300 connects to the V1000 through a high speed RS-485 network. The V1000 communicates with the system host via industry standard TCP/IP protocol over 10/100 Mbps Ethernet or the Internet. This architecture minimizes the impact on corporate LANs, by using only one TCP/IP address for every 32 Interfaces, and by handling low-level transactions on the RS-485 network.

Featured

  • Off-normal status programmable for each input point (NO or NC alarm devices may be used).
  • 12 latching Form-C relays, contacts rated at 2A @ 30VDC.
  • Connects to the V1000 via RS-485.
  • Receives and processes real time commands from the V1000.
  • Reports all activity to the V1000.
  • Allows complex input/output linking when used with the V1000 and V200.
  • Attractive polycarbonate enclosure protects components from damage.
  • All connections and indicators are fully identified by silk-screened nomenclature on the cover.
  • UL 294 and UL 1076 recognized component.

Specification

Dimensions: 5.8" W x 4.825" H x 1.275" D (147.32 mm x 122.55 mm x 32.38 mm)

Weight: 13.6 oz (.38 kg)

Power Supply Requirements: 60 mA @ 9-18 VDCRecommended: supervised linear power supply with battery backup, input surge protection, and AC Fail and battery low contact outputs. Separate supervised, DC supply with battery back-up recommended for relay activated devices.

Cable Distance:

    • RS-485 - 4000 feet (1220 m) to host using Belden 3105A, 22 AWG twisted pair, shielded 100? cable.
  • Output Circuits - 500 feet (150 m), 2-conductor, using ALPHA 1172C (22AWG) or Alpha 1897C (18AWG). Minimum wire gauge depends on cable length and current requirements.

Certifications:

    • UL 294 and UL 1076 Recognized Component for the US
    • CSA 205 for Canada
    • FCC Class A Verification
    • EMC for Canada, EU (CE Mark), Australia (C-Tick Mark),
      New Zealand, Japan
  • EN 50130-4 Access Control Systems Immunity for the EU (CE Mark)
   

Copyright © datascrip.com, 2015 All Rights Reserved


Customer Care : 
(021) 2664 8999